|
}} The Horton Mill Covered Bridge is a state owned wooden covered bridge that spans the Calvert Prong of the Little Warrior River in Blount County, Alabama, United States. It is located on a river crossover (Horton Mill Road) to Ebell Road and Covered Bridge Circle off State Route 75 about 5 miles (8 kilometers) north of the city of Oneonta. Coordinates are (34.007644, -86.448625). Built in 1934, the 220-foot (67-meter) bridge is a Town Lattice truss construction over two spans. Its WGCB number is 01-05-07. The Horton Mill Covered Bridge was listed on the National Register of Historic Places on December 29, 1970, the first covered bridge in the southeastern United States to be added. At 70 feet (21 m), it is the highest covered bridge above any U.S. waterway. It was reopened on March 11, 2013 after being closed in 2007 due to vandalism. The bridge is currently open to motor vehicle traffic. However, there is only one lane and the posted speed limit is 5 MPH. The Horton Mill Covered Bridge is maintained by the Alabama Historical Commission, Blount County Commission and the Alabama Department of Transportation. ==History== The original Horton Mill Covered Bridge was built in 1894 at the foot of Sand Mountain, about 3/4 mile (1 kilometer) downstream from the current bridge. It was named for a local business owned by Thurman M. Horton, who helped construct the first bridge. This bridge allowed residents of Sand Mountain a better means of access to nearby Oneonta as well as to Horton's mill and general store which were located along the east side of the Calvert Prong. Construction of the current Horton Mill Covered Bridge began in 1934 over a deep gorge cut by the river, led by Talmedge Horton...a family descendent of Thurman Horton. It took a 15-man crew 1½ years to complete the project. This crew included Zelma C. Tidwell and his uncle, Forrest Tidwell, who helped in building three other prominent covered bridges in Blount County (Easley, Nectar, Swann). The bridge was fully restored in 1974 by the Alabama Historical Commission and the Blount County Commission. It is one of three historic covered bridges remaining in Blount County. The Horton Mill Covered Bridge was reported closed to motor vehicle traffic on September 27, 2007 due to unsafe conditions. According to a member on the photo website Flickr as well as a report from the ''The Blount Countian'', vandals attempted to remove some of the roof supports on the west side of the bridge by tying a cable or chain around them and attached the other end to either a tow hitch or hook...using a vehicle to try to pull them out, causing significant damage. A photo showing the damaged end of the Horton Mill Covered Bridge can be seen by clicking the reference link to Flickr below. The other two historic covered bridges remaining in Blount County, Easley and Swann, were closed to motor vehicle traffic in 2009 for unsafe conditions after routine inspections. Restoration of all three covered bridges began in late 2011 starting with the Swann Covered Bridge near Cleveland, Alabama. Money for these projects primarily came from the federal National Historic Covered Bridge Preservation Program as well as transportation enhancement funds. The $469,110 construction contract was awarded to Bob Smith Construction of Trussville, Alabama. The Horton Mill Covered Bridge would be the last to be restored due to its high elevation above the river which made things more challenging. Wooden structural pieces were repaired or replaced as needed and new tin roofs were put on all three bridges in order to keep the weather off vital supporting timbers. Total restoration costs for the covered bridges was approximately $540,000. The difference was covered by county expenditures. Following necessary repairs and upgrades, the Horton Mill Covered Bridge was reopened to motor vehicle traffic on March 11, 2013. 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Horton Mill Covered Bridge」の詳細全文を読む スポンサード リンク
|